Browse Helix Models and Effects

Helix currently supports 72 amplifier models, 194 effects, 37 speaker cab models, and 16 microphones. On top of all that you also have the ability to load Impulse Responses (IRs) that you can grab from free or paid sources. Go have fun.

Stock delay settings. Played with a Charvel Classic 475 using the Deluxe Reverb amp model, default amp and cab settings.

Line 6 Original delay with reverb injected into the feedback loop.

• Time—Sets the delay time. Press the knob to toggle between ms/Sec and note values
  
• Feedback—Controls the overall number of repeats. To hear only one repeat, set to 0%
  
• Mix—Controls the wet/dry mix of the delay. When set to 0%, no delay is heard; when set to 100%, no dry signal is heard
  
• Rev Mix—Controls the wet/dry mix of the reverb inside the delay's feedback loop. When set to 0%, no reverb is heard
  
• Rev Decay—Sets the decay of the reverb
  
• Headroom—Some delay pedals' internal signal paths exhibit a bit of grit, especially when placed after a high-gain amp block. Negative values increase the perceived amount of grit; positive values clean things up a bit. At 0dB, the model behaves like the original pedal
  
• Level—Sets the overall level of the block
  
• Trails—When set to "Off," delay repeats are instantly muted when the block is bypassed. When set to "On," delay repeats continue to decay naturally when the block is bypassed or a different snapshot is selected
  

Description source: Line 6
Image source: Line 6

There are no comments for this yet.