Browse Helix Models and Effects

Helix currently supports 72 amplifier models, 194 effects, 37 speaker cab models, and 16 microphones. On top of all that you also have the ability to load Impulse Responses (IRs) that you can grab from free or paid sources. Go have fun.

Pillars (Earthquaker Devices Plumes)

Pillars, the Helix model of a Earthquaker Devices Plumes

Plumes® is a unique, all-analog approach to a classic tube-like overdrive circuit offering 3 different clipping voices, loads of headroom and almost three-dimensional clarity that will push your amp over the edge. The reimagined tone control is finely tuned to sculpt low end, clear top end, and focus midrange with blooming sustain.

There are three clipping modes available:


  1. Symmetrical LED clipping - More Crunch and Compression

  2. No clipping - Wide open OpAmp drive for clean boost

  3. Asymmetrical silicon diode clipping - More transparency with a loose feel



Description source: Earthquaker Devices


Cranked 800

The new JCM 800 2203 from Helix 3.7 in all its glory.

Soundcloud
  • 👇 Downloads: 245
  • 🤘 Upvotes: 6
  • Member: Jorge
  • Performance Type:
    Direct (Recording, Headphone, PA)


Cranked Princess

Nice crunchy Fender amp with extra sizzle from the new Pillars OD in Helix 3.5.

  • 👇 Downloads: 200
  • 🤘 Upvotes: 1
  • Member: Jorge
  • Performance Type:
    Direct (Recording, Headphone, PA)


Patch Performance
Type
Description Member 👇 Downloads 🤘 Upvotes
Cranked 800
Soundcloud
Direct (Recording, Headphone, PA) The new JCM 800 2203 from Helix 3.7 in all its glory. Jorge 245 6
Cranked Princess Direct (Recording, Headphone, PA) Nice crunchy Fender amp with extra sizzle from the new Pillars OD in Helix 3.5. Jorge 200 1
Comments    

There are no comments for this yet.

Some Products That We Love

Brought to you by the Fluid Solo department of Commerce

Add some Footswitches to your Rig

A simple and cost effective way to add 2 additional footswitches to your HX Stomp or other HX device. Yes, including Pod Go! Please be advised that you will also need a TRS type 1/4 inch cable to use both switches.

Add some Footswitches to your Rig

Last seen around $22

Put Some Pedal Toppers On!

Pedal toppers make switching easier by giving you more surface area for your feet.

Put Some Pedal Toppers On!

Last seen around $9 for a ten-pack

Extra Power Cable for your HX Stomp

I've been using one of these power supplies permanently zip-tied to my pedalboard, and it's been very handy to keep the original power supply around for off-board usage. Plus it's cheap and works well.

Extra Power Cable for your HX Stomp

Last seen around $16