Browse Helix Models and Effects

Helix currently supports 111 amplifier models, 276 effects, 56 speaker cab models, and 16 microphones. On top of all that you also have the ability to load Impulse Responses (IRs) that you can grab from free or paid sources. Go have fun.

Minotaur (Klon® Centaur)

Minotaur, the Helix model of a Klon® Centaur

Recorded using a Les Paul with Burstbucker pickups into a Twin Reverb model with the normal input. The overdrive pedal and amp are set at default settings. A touch of reverb added for depth.

The Klon Centaur is a guitar overdrive pedal developed by Bill Finnegan between 1990 and 1994. The pedals were made manually by Finnegan. The Centaur is characterized as a "transparent" overdrive, meaning it adds gain to the signal without significantly altering the tone of the guitar.

Depending on the settings of the control knobs, the pedal can act mostly as a clean boost, adding mostly volume and minimal coloring to the sound. This can be used to drive the input valve stage of the amplifier to use the characteristic distortion sound of an overdriven guitar amp. Alternatively (or additionally) the controls can be set to distort the sound signal in the pedal, where two germanium diodes can perform waveform clipping (see clipping (audio)). The "gain" knob is a double potentiometer (a "dual-ganged gain pot"), which controls bass and middle frequencies. Other knobs are treble and volume.

Image source: Thaddeus Hogarth


AC 30 Tone for Boss Katana Amps

Use this patch by plugging straight into a Katana 50. Use the acoustic channel on the amp, and keep all Katana settings at noon, and adjust to taste. This patch uses the "A30 Fawn Brt" Helix model for a chimey AC30 tone. Use the Klon for some nice hot overdrive. There's some spring reverb included to round out the tone. Sounds great on the Katana combo.

  • 👇 Downloads: 606
  • 🤘 Upvotes: 3
  • Member: Jorge
  • Device:
    HX Stomp
  • Performance Type:
    Plugged in Front of the Amp


Come on Let's Go

I love all of the Los Lobos Ritchie Valens covers on the La Bamba soundtrack.This patch replicates the rhythm and lead tones on "Come On Let's Go". It can probably fit in nicely with La Bamba and the others too. Use the Minotaur for the lead tone.Use a strat for this patch, I think the bridge + middle pickup position fits the best.

Youtube
  • 👇 Downloads: 516
  • 🤘 Upvotes: 3
  • Member: Jorge
  • Device:
    HX Stomp
  • Performance Type:
    Direct (Recording, Headphone, PA)


Mike Ness Tone

This is a very good aproximation of Mike Ness's Tone on the Social Distortion albums. The recipe is iconic - a dirt pedal into a Bassman head, then into Marshall cabinets. The sample clip was played on a legit Les Paul with P90 pickups - you need this to get the real deal.

Soundcloud
  • 👇 Downloads: 168
  • 🤘 Upvotes: 2
  • Member: Jorge
  • Device:
    Helix Floor
  • Performance Type:
    Direct (Recording, Headphone, PA)


Jingle Jangle

12 string into a chime amp = awesome. The Soundcloud demo below was made with Logic drums, and I used my "Guitar Goes Bass" preset available here on fluid solo to create the bass guitar sound. No bass guitar needed. Listen for the organ-like fadeout, very cool.

Soundcloud
  • 👇 Downloads: 147
  • 🤘 Upvotes: 2
  • Member: Jorge
  • Device:
    Helix Floor
  • Performance Type:
    Direct (Recording, Headphone, PA)


Hellbound Fender for Powercab

This tone is an attempt to capture the live tone of one of my favorite guitarists, Luis from Hellbound Hayride. It's a juicy, dirty Fender sound with some delay and reverb. The tone does not have a cab emulation in it, it uses the Powercab for that.Powercab SettingsSet the Powercab to the "Vintage" (Celestion Vintage 30) speaker emulation and turn it up!

Soundcloud
  • 👇 Downloads: 437
  • 🤘 Upvotes: 1
  • Member: Jorge
  • Device:
    HX Stomp
  • Performance Type:
    Line 6 Powercab


Dimed Tweed Les Paul

From Joost Assink: I had set myself the goal to master all the parts in the epic final solo of Hotel California in my downtime during this crisis. I found out there are 11 parts!! (6 electric guitars, 2 acoustic guitars, 1 bass part, the organ part and of course programming drums). Well, it took a little longer than expected. I recorded all electric guitars and the bass using line 6 helix into an Apollo X8. I recorded the acoustic guitars with a stereo set of Neumann KM184s and I mixed everything in the new Universal Audio Luna DAW. I used a custom patch based on the tweed amp with a custom IR for all the electric guitars and I use the standard Cali 1 bass preset for the bass guitar. For the solos, I enabled a tube screamer, and for the telecaster parts, I added the script mod phaser pedal. For the reggae rhythm, I enabled the Wah pedal in a fixed position and for the supporting electric guitar lines, I added a little bit of chorus. Here's a free link to the IR used in the Youtube video:

Youtube
  • 👇 Downloads: 345
  • 🤘 Upvotes: 1
  • Member: Jorge
  • Device:
    Helix Floor
  • Performance Type:
    Direct (Recording, Headphone, PA)


Boys dont cry H

Song: Boys don't cryArtist: The CureTwo snapshots: 1. Clean. 2. Lead (for the melody). 3. and 4. Not used. I used the jazz chorus 120 and one ownhammer IR OH 112 DLXVRB C12R OH2-M+. If you can't get the ownhammer IR, the patch still working with the 2x12 Jazz Rivet cabinet included in the POD Go. Let me know if useful thru the rating section. Hernan

  • 👇 Downloads: 437
  • 🤘 Upvotes: 1
  • Member: Hernan93
  • Device:
    Pod Go
  • Performance Type:
    Direct (Recording, Headphone, PA)


Amp Switcher with Effects

This patch allows you to send a channel switch command to your amp via the HX Effect's built in capabilities for channel switching, while at the same time toggling effects on and off with the 2 snapshots. On my personal setting, the "soft" snapshot is still dirty by using the Klon model, but the "hard" snapshot is using  my amp's gain.There is no 4 cable method used here, it's just the HX Effects switching my amp channels for me, and toggling some effects.NOTE: to use this patch, you will need to set the Pedal 2 Jack setting to "Amp2" in the device settings of the HX effects.

  • 👇 Downloads: 102
  • 🤘 Upvotes: 1
  • Member: Jorge
  • Device:
    HX Effects
  • Performance Type:
    Plugged in Front of the Amp


Rock Pedalboard

Cool rock pedalboard setup that I run straight into the clean channel of a  Mesa Mini Rectifier.

  • 👇 Downloads: 196
  • 🤘 Upvotes: 1
  • Member: Jorge
  • Device:
    HX Effects
  • Performance Type:
    Plugged in Front of the Amp


1 More Block for Pod Go

This patch removes the effects loop and provides an additional block for effects. In this patch we have available:4 Voice ChorusHorizon GateKinky BoostMinotaur60s Bias TremPlease modify the effects to your liking. Be aware that this patch does not impact the processing power of the Pod Go, so you may need to tweak your effects if you run into DSP limits.

  • 👇 Downloads: 110
  • 🤘 Upvotes: 1
  • Member: Jorge
  • Device:
    Pod Go
  • Performance Type:
    Plugged in Front of the Amp


Patch Device Performance
Type
Description Member 👇 Downloads 🤘 Upvotes
AC 30 Tone for Boss Katana Amps HX Stomp Plugged in Front of the Amp Use this patch by plugging straight into a Katana 50. Use the acoustic channel on the amp, and keep all Katana settings at noon, and adjust to taste. This patch uses the "A30 Fawn Brt" Helix model for a chimey AC30 tone. Use the Klon for some nice hot overdrive. There's some spring reverb includ… Jorge 606 3
Come on Let's Go
Youtube
HX Stomp Direct (Recording, Headphone, PA) I love all of the Los Lobos Ritchie Valens covers on the La Bamba soundtrack.This patch replicates the rhythm and lead tones on "Come On Let's Go". It can probably fit in nicely with La Bamba and the others too. Use the Minotaur for the lead tone.Use a strat for this patch, I think the bridge + mid… Jorge 516 3
Mike Ness Tone
Soundcloud
Helix Floor Direct (Recording, Headphone, PA) This is a very good aproximation of Mike Ness's Tone on the Social Distortion albums. The recipe is iconic - a dirt pedal into a Bassman head, then into Marshall cabinets. The sample clip was played on a legit Les Paul with P90 pickups - you need this to get the real deal. Jorge 168 2
Jingle Jangle
Soundcloud
Helix Floor Direct (Recording, Headphone, PA) 12 string into a chime amp = awesome. The Soundcloud demo below was made with Logic drums, and I used my "Guitar Goes Bass" preset available here on fluid solo to create the bass guitar sound. No bass guitar needed. Listen for the organ-like fadeout, very cool. Jorge 147 2
Hellbound Fender for Powercab
Soundcloud
HX Stomp Line 6 Powercab This tone is an attempt to capture the live tone of one of my favorite guitarists, Luis from Hellbound Hayride. It's a juicy, dirty Fender sound with some delay and reverb. The tone does not have a cab emulation in it, it uses the Powercab for that.Powercab SettingsSet the Powercab to the… Jorge 437 1
Dimed Tweed Les Paul
Youtube
Helix Floor Direct (Recording, Headphone, PA) From Joost Assink: I had set myself the goal to master all the parts in the epic final solo of Hotel California in my downtime during this crisis. I found out there are 11 parts!! (6 electric guitars, 2 acoustic guitars, 1 bass part, the organ part and of course programming drums). Well, it took… Jorge 345 1
Boys dont cry H Pod Go Direct (Recording, Headphone, PA) Song: Boys don't cryArtist: The CureTwo snapshots: 1. Clean. 2. Lead (for the melody). 3. and 4. Not used. I used the jazz chorus 120 and one ownhammer IR OH 112 DLXVRB C12R OH2-M+. If you can't get the ownhammer IR, the patch still working with the 2x12 Jazz Rivet cabinet included in the POD Go. L… Hernan93 437 1
Amp Switcher with Effects HX Effects Plugged in Front of the Amp This patch allows you to send a channel switch command to your amp via the HX Effect's built in capabilities for channel switching, while at the same time toggling effects on and off with the 2 snapshots. On my personal setting, the "soft" snapshot is still dirty by using the Klon model, but the "h… Jorge 102 1
Rock Pedalboard HX Effects Plugged in Front of the Amp Cool rock pedalboard setup that I run straight into the clean channel of a  Mesa Mini Rectifier. Jorge 196 1
1 More Block for Pod Go Pod Go Plugged in Front of the Amp This patch removes the effects loop and provides an additional block for effects. In this patch we have available:4 Voice ChorusHorizon GateKinky BoostMinotaur60s Bias TremPlease modify the effects to your liking. Be aware that this patch does not impact the processing power of the Pod Go, so you m… Jorge 110 1
Comments    

There are no comments for this yet.

Some Products That We Love

Brought to you by the Fluid Solo department of Commerce

A Handy Rechargeable Tuner

Those snark-y headstock tuners are great, but it gets old changing out those coin-sized batteries. This rechargeable unit makes tuning a breeze.

A Handy Rechargeable Tuner

Last seen at $29

Rechargeable FRFR Amp For Your Modeler

The new Headrush FRFR Go is a cool solution to take your modeler tones on the go for practice use.

Rechargeable FRFR Amp For Your Modeler

Last seen at $150

Power your HX Stomp via USB

This handy cord allows you to power your HX Stomp from a USB port, so you can power it from a USB power bank or other power source.

Power your HX Stomp via USB

Last seen around $23