Browse Helix Models and Effects
Helix currently supports 72 amplifier models, 194 effects, 37 speaker cab models, and 16 microphones. On top of all that you also have the ability to load Impulse Responses (IRs) that you can grab from free or paid sources. Go have fun.
Mono FX Loop (Mono FX Loop)
A mono FX Loop activates the effects loop within the Helix device to enable the use of additional effects devices. This effect is using only mono input and output.
GrindBass
This is a fun bass patch. With 3 snaps. Snap 1 is EQed with chorus. Snap2 is is Grimey little crunchy and fat. Snap 3 is balls to the wall all in. Loud crunchy and fat. edit it, delete it, hate it all for your jamming pleasure. Email me if you want kd0ytb at hotmail dot com
- π Downloads: 424
- π€ Upvotes: 3
- Member: N0rsn
- Performance Type:
Direct (Recording, Headphone, PA)
God Tone with Looper
Incredible clean and dirty tones in one patch with lots of different applications.Clean Mark amp with 2 stages of Overdrive - a Parametric EQ pushed the amp into overdrive, and a Timmy pedal pushes it out into full distortion. No snapshots, I find the pedal assignments can do the job.
- π Downloads: 882
- π€ Upvotes: 2
- Member: Jorge
- Performance Type:
Direct (Recording, Headphone, PA)
Downtown Fullerton
Try this tone with a strat, and roll back on your volume just a bit. Sounds nice.
- π Downloads: 482
- π€ Upvotes: 2
- Member: Jorge
- Performance Type:
Direct (Recording, Headphone, PA)
Heretick Riffs
My current personal metal riffing sound, based on the Line 6 Fatality. Tight and percussive, but in a thrashy way. No cab modeling, since I use my Pod Go into a power amp into a Vintage 30 equipped cab.
- π Downloads: 330
- π€ Upvotes: 2
- Member: Heretick
- Performance Type:
Plugged in Front of the Amp
Vibrolux Kitchen Sink
The preset features a clean Vibrolux with two gain options; the EQ is set in front of the amp with a boost and there is a Kinky Boost between the amp and cab with a boost. It also has a transistor tape delay, chorus, and reverb - season to taste. I use this with my single coil guitars, but it should work fine with humbuckers. It's a sort of generic, catch-all preset.
- π Downloads: 282
- π€ Upvotes: 2
- Member: Wagdog
- Performance Type:
Direct (Recording, Headphone, PA)
MM Set HD K2 Dha
This is full set with 4 snapshots: 1. Clean Chorus, 2. Overdrive (bluesy), 3. Mid Gain and 4. High Gain which can cover a lot. Snapshots 2-3 can be used either as rhythm (without delay or/and chorus) and lead tones. All snapshots are aimed to reproduce tube amp, with sufficient tone definition and to cut through the mix. The tone is made for PAF pickups (7.5 K neck and 11 K bridge), but tested (and sounds good) on high resistance, "hot" pups as well (Ibanez Quantum).
Soundcloud- π Downloads: 283
- π€ Upvotes: 2
- Member: Mvmilosevic
- Performance Type:
Direct (Recording, Headphone, PA)
Hotel California
Solo Sound with Brit Plexi BRT
- π Downloads: 264
- π€ Upvotes: 2
- Member: Ustraub
- Performance Type:
Direct (Recording, Headphone, PA)
Silence
This utility patch is intended to reduce the hum and hiss of your noisy high gain amp. It is composed of 2 noise gates, one for your guitar and another for the amp's FX loop. The patch needs to run in the "4 Cable Method" to work properly. I use this patch to tame the hiss on my Mesa Boogie Mini Rectifier. It's a great amp but has a bit of hiss due to the high gain nature of the amp. By putting a noise gate in your amp's effects loop, you are mostly getting rid of any annoying hiss or hum that is in the amp's preamp section.
- π Downloads: 198
- π€ Upvotes: 1
- Member: Jorge
- Performance Type:
4 Cable Method
Phil X Pod Go
This patch is based off of the information on this post on The Gear Page. It's a simple Placater dirty amp into a delay. The amp settings are identical to those in the discussion, and instead of an IR, this version uses a stock cab. Adjust to taste, as always.
- π Downloads: 435
- π€ Upvotes: 1
- Member: Jorge
- Performance Type:
Direct (Recording, Headphone, PA)
Phil X Pod Go IR
This patch is based off of the information on this post on The Gear Page. It's a simple Placater dirty amp into a delay. The amp settings are identical to those in the discussion, and uses the same IR as was discussed in the post.The IR can be downloaded for free from here:dropbox.com
- π Downloads: 368
- π€ Upvotes: 1
- Member: Jorge
- Performance Type:
Direct (Recording, Headphone, PA)
Patch | Performance Type |
Description | Member | π Downloads | π€ Upvotes |
---|---|---|---|---|---|
GrindBass | Direct (Recording, Headphone, PA) | This is a fun bass patch. With 3 snaps. Snap 1 is EQed with chorus. Snap2 is is Grimey little crunchy and fat. Snap 3 is balls to the wall all in. Loud crunchy and fat. edit it, delete it, hate it all for your jamming pleasure. Email me if you want kd0ytb at hotmail dot com | N0rsn | 424 | 3 |
God Tone with Looper | Direct (Recording, Headphone, PA) | Incredible clean and dirty tones in one patch with lots of different applications.Clean Mark amp with 2 stages of Overdrive - a Parametric EQ pushed the amp into overdrive, and a Timmy pedal pushes it out into full distortion. No snapshots, I find the pedal assignments can do the job. | Jorge | 882 | 2 |
Downtown Fullerton | Direct (Recording, Headphone, PA) | Try this tone with a strat, and roll back on your volume just a bit. Sounds nice. | Jorge | 482 | 2 |
Heretick Riffs | Plugged in Front of the Amp | My current personal metal riffing sound, based on the Line 6 Fatality. Tight and percussive, but in a thrashy way. No cab modeling, since I use my Pod Go into a power amp into a Vintage 30 equipped cab. | Heretick | 330 | 2 |
Vibrolux Kitchen Sink | Direct (Recording, Headphone, PA) | The preset features a clean Vibrolux with two gain options; the EQ is set in front of the amp with a boost and there is a Kinky Boost between the amp and cab with a boost. It also has a transistor tape delay, chorus, and reverb - season to taste. I use this with my single coil guitars, but it shoul⦠| Wagdog | 282 | 2 |
MM Set HD K2 Dha
Soundcloud |
Direct (Recording, Headphone, PA) | This is full set with 4 snapshots: 1. Clean Chorus, 2. Overdrive (bluesy), 3. Mid Gain and 4. High Gain which can cover a lot. Snapshots 2-3 can be used either as rhythm (without delay or/and chorus) and lead tones. All snapshots are aimed to reproduce tube amp, with sufficient tone definition and β¦ | Mvmilosevic | 283 | 2 |
Hotel California | Direct (Recording, Headphone, PA) | Solo Sound with Brit Plexi BRT | Ustraub | 264 | 2 |
Silence | 4 Cable Method | This utility patch is intended to reduce the hum and hiss of your noisy high gain amp. It is composed of 2 noise gates, one for your guitar and another for the amp's FX loop. The patch needs to run in the "4 Cable Method" to work properly. I use this patch to tame the hiss on my Mesa Boogie Mini⦠| Jorge | 198 | 1 |
Phil X Pod Go | Direct (Recording, Headphone, PA) | This patch is based off of the information on this post on The Gear Page. It's a simple Placater dirty amp into a delay. The amp settings are identical to those in the discussion, and instead of an IR, this version uses a stock cab. Adjust to taste, as always. | Jorge | 435 | 1 |
Phil X Pod Go IR | Direct (Recording, Headphone, PA) | This patch is based off of the information on this post on The Gear Page. It's a simple Placater dirty amp into a delay. The amp settings are identical to those in the discussion, and uses the same IR as was discussed in the post.The IR can be downloaded for free from here:dropbox.com | Jorge | 368 | 1 |
Comments
There are no comments for this yet.
Some Products That We Love
Brought to you by the Fluid Solo department of CommerceExpand your effects with HX One
The HX One gives you the world of Line 6's effects in a compact pedal. It's a great addition to your pedalboard, giving you the ability to expand the processing power of your rig, whether or not you have an HX device or Pod Go already.
Last seen at $300
Power your HX Stomp via USB
This handy cord allows you to power your HX Stomp from a USB port, so you can power it from a USB power bank or other power source.
Last seen around $23
Add some Footswitches to your Rig
A simple and cost effective way to add 2 additional footswitches to your HX Stomp or other HX device. Yes, including Pod Go! Please be advised that you will also need a TRS type 1/4 inch cable to use both switches.
Last seen around $22