Browse Helix Models and Effects
Helix currently supports 111 amplifier models, 276 effects, 56 speaker cab models, and 16 microphones. On top of all that you also have the ability to load Impulse Responses (IRs) that you can grab from free or paid sources. Go have fun.
Volume Pedal (Line 6® Original)
It's a volume pedal. How complicated can it be. Push down to go louder - or is it the other way around?
Vibrolux Kitchen Sink
The preset features a clean Vibrolux with two gain options; the EQ is set in front of the amp with a boost and there is a Kinky Boost between the amp and cab with a boost. It also has a transistor tape delay, chorus, and reverb - season to taste. I use this with my single coil guitars, but it should work fine with humbuckers. It's a sort of generic, catch-all preset.
- 👇 Downloads: 370
- 🤘 Upvotes: 2
- Member: Wagdog
- Performance Type:
Direct (Recording, Headphone, PA)
- 👇 Downloads: 204
- 🤘 Upvotes: 2
- Member: Madguitar78
- Performance Type:
Direct (Recording, Headphone, PA)
MM Set HD K2 Dha
This is full set with 4 snapshots: 1. Clean Chorus, 2. Overdrive (bluesy), 3. Mid Gain and 4. High Gain which can cover a lot. Snapshots 2-3 can be used either as rhythm (without delay or/and chorus) and lead tones. All snapshots are aimed to reproduce tube amp, with sufficient tone definition and to cut through the mix. The tone is made for PAF pickups (7.5 K neck and 11 K bridge), but tested (and sounds good) on high resistance, "hot" pups as well (Ibanez Quantum).
Soundcloud- 👇 Downloads: 489
- 🤘 Upvotes: 2
- Member: Mvmilosevic
- Performance Type:
Direct (Recording, Headphone, PA)
Revv Gen Red
This is the default patch for the Revv Gen Red model from the stock presets of the Helix 2.8 update. This may be useful to you if you didn't overwrite the presets on your device.You must be running 2.8 Firmware, or the 1.8 firmware on Helix Native.
- 👇 Downloads: 129
- 🤘 Upvotes: 1
- Member: Jorge
- Performance Type:
Direct (Recording, Headphone, PA)
Phil X Pod Go
This patch is based off of the information on this post on The Gear Page. It's a simple Placater dirty amp into a delay. The amp settings are identical to those in the discussion, and instead of an IR, this version uses a stock cab. Adjust to taste, as always.
- 👇 Downloads: 536
- 🤘 Upvotes: 1
- Member: Jorge
- Performance Type:
Direct (Recording, Headphone, PA)
Phil X Pod Go IR
This patch is based off of the information on this post on The Gear Page. It's a simple Placater dirty amp into a delay. The amp settings are identical to those in the discussion, and uses the same IR as was discussed in the post.The IR can be downloaded for free from here:dropbox.com
- 👇 Downloads: 441
- 🤘 Upvotes: 1
- Member: Jorge
- Performance Type:
Direct (Recording, Headphone, PA)
- 👇 Downloads: 152
- 🤘 Upvotes: 1
- Member: Madguitar78
- Performance Type:
Direct (Recording, Headphone, PA)
- 👇 Downloads: 297
- 🤘 Upvotes: 1
- Member: Madguitar78
- Performance Type:
Direct (Recording, Headphone, PA)
- 👇 Downloads: 115
- 🤘 Upvotes: 1
- Member: Madguitar78
- Performance Type:
Direct (Recording, Headphone, PA)
Boys dont cry H
Song: Boys don't cryArtist: The CureTwo snapshots: 1. Clean. 2. Lead (for the melody). 3. and 4. Not used. I used the jazz chorus 120 and one ownhammer IR OH 112 DLXVRB C12R OH2-M+. If you can't get the ownhammer IR, the patch still working with the 2x12 Jazz Rivet cabinet included in the POD Go. Let me know if useful thru the rating section. Hernan
- 👇 Downloads: 388
- 🤘 Upvotes: 1
- Member: Hernan93
- Performance Type:
Direct (Recording, Headphone, PA)
| Patch | Performance Type |
Description | Member | 👇 Downloads | 🤘 Upvotes |
|---|---|---|---|---|---|
| Vibrolux Kitchen Sink | Direct (Recording, Headphone, PA) | The preset features a clean Vibrolux with two gain options; the EQ is set in front of the amp with a boost and there is a Kinky Boost between the amp and cab with a boost. It also has a transistor tape delay, chorus, and reverb - season to taste. I use this with my single coil guitars, but it shoul… | Wagdog | 370 | 2 |
|
Run to you
Youtube |
Direct (Recording, Headphone, PA) | Brian Adams Run to you | Madguitar78 | 204 | 2 |
|
MM Set HD K2 Dha
Soundcloud |
Direct (Recording, Headphone, PA) | This is full set with 4 snapshots: 1. Clean Chorus, 2. Overdrive (bluesy), 3. Mid Gain and 4. High Gain which can cover a lot. Snapshots 2-3 can be used either as rhythm (without delay or/and chorus) and lead tones. All snapshots are aimed to reproduce tube amp, with sufficient tone definition and … | Mvmilosevic | 489 | 2 |
| Revv Gen Red | Direct (Recording, Headphone, PA) | This is the default patch for the Revv Gen Red model from the stock presets of the Helix 2.8 update. This may be useful to you if you didn't overwrite the presets on your device.You must be running 2.8 Firmware, or the 1.8 firmware on Helix Native. | Jorge | 129 | 1 |
| Phil X Pod Go | Direct (Recording, Headphone, PA) | This patch is based off of the information on this post on The Gear Page. It's a simple Placater dirty amp into a delay. The amp settings are identical to those in the discussion, and instead of an IR, this version uses a stock cab. Adjust to taste, as always. | Jorge | 536 | 1 |
| Phil X Pod Go IR | Direct (Recording, Headphone, PA) | This patch is based off of the information on this post on The Gear Page. It's a simple Placater dirty amp into a delay. The amp settings are identical to those in the discussion, and uses the same IR as was discussed in the post.The IR can be downloaded for free from here:dropbox.com | Jorge | 441 | 1 |
|
BMay Helix
Youtube |
Direct (Recording, Headphone, PA) | Used for Hammer to fall | Madguitar78 | 152 | 1 |
|
Livin on a prayer
Youtube |
Direct (Recording, Headphone, PA) | Richie Sambora kind of sound | Madguitar78 | 297 | 1 |
|
SlashStock
Youtube |
Direct (Recording, Headphone, PA) | Used for Slask sound | Madguitar78 | 115 | 1 |
| Boys dont cry H | Direct (Recording, Headphone, PA) | Song: Boys don't cryArtist: The CureTwo snapshots: 1. Clean. 2. Lead (for the melody). 3. and 4. Not used. I used the jazz chorus 120 and one ownhammer IR OH 112 DLXVRB C12R OH2-M+. If you can't get the ownhammer IR, the patch still working with the 2x12 Jazz Rivet cabinet included in the POD Go. L… | Hernan93 | 388 | 1 |
Comments
There are no comments for this yet.
Some Products That We Love
Brought to you by the Fluid Solo department of CommercePower your HX Stomp via USB
This handy cord allows you to power your HX Stomp from a USB port, so you can power it from a USB power bank or other power source.
Last seen around $23
Put Some Pedal Toppers On!
Pedal toppers make switching easier by giving you more surface area for your feet.
Last seen around $9 for a ten-pack
Add some Footswitches to your Rig
A simple and cost effective way to add 2 additional footswitches to your HX Stomp or other HX device. Yes, including Pod Go! Please be advised that you will also need a TRS type 1/4 inch cable to use both switches.
Last seen around $22